Found this bench vise a few years back that someone put out for trash. After removing all that rust, it looks/works good as new. I found some Rust-olium red paint and decided on that.
Sunday, April 12, 2020
Friday, April 10, 2020
I've removed all of the clapboards and trim from the last side of my house, but unlike the other sides I need to replace the bottom trim. Anyone have recommendations on how I achieve this cut that allows the first row of clapboard be canted? I assume I can do it with a router, but I don't have the correct bit.
Sunday, October 27, 2019
Be sure to check out Everyday Old House especially if you own a foursquare.
Jen has lots of great information about American Foursquare homes as well as a list of blogs to follow. Nice of Jen to add my house to the list!
Sunday, October 20, 2019
Every Sat. morning I take my dog for a long walk and listen to the Fine Homebuilding podcast. If you haven't listened to it before, I highly recommend it. I had sent them a question a while back about power venting my boiler and hot water heater and they were kind enough to answer in their latest podcast in the link below. They were very positive about this blog, and really made my day! I'll really be looking forward to getting rid of that chimney even though it will be a while until I get to it. My question is mentioned toward the end of the podcast around 42 minutes.
Thanks so much Patrick McCombe, Matthew Millham & Kiley Jacques of the Fine Homebuilding Podcast!
Sunday, October 13, 2019
I will have two window awnings and one door awning to replace on this side of the house. I originally thought I'd build a large awning over the door, but it looks like the original was quite small, just like the windows. I did one on the other side of the house, but I think the awning extends out a bit too much. This time around I'll keep it much shorter and use the same Azek moulding I used for the soffit up top. I think that will be perfect.
Saturday, October 12, 2019
All of the sills on my house were hacked off at the ends when the aluminum siding was installed. The first sill I replaced I used wood from Home Depot which was a bad idea since the wood didn't have time to cure. That part of the sill shrunk within 6 months. Luckily it was just that one window. It's best to go to a lumber yard and get the correct size wood that has already cured.
The process here is to cut the ends flush with an oscillating tool or hand saw if you can manage. I'll then cut the wood to size and coat the wood with Gorilla Glue and the house/window with water. I use a spray bottle for this. Once in contact I send a nail or two up through the bottom. This process is sometimes easier if you use a screw that is already counter sunk. You can take the screw out after the glue has cured.
After the glue has cured I use bondo to fill any gaps and nail holes and sand with 80 grit. Once that's done I paint the entire window in oil base paint. I then use bondo again to fill any holes. Easier to see when it's painted white. Sand again, and then cover in latex paint. Oil base paint (I like Zinsser) sands easily and will leave you a nice smooth surface before painting with latex.
Friday, October 11, 2019
Just about all of the new homes I photograph power vent the furnace and hot water heater out the side of the house. Anyone that has a foursquare with a chimney going straight through their house could benefit greatly by using one of these including myself. I'm trying to find out the downsides of using such a contraption. I asked this question to the Fine Homebuilding podcast and I'm crossing my fingers that it will be used. I'd be curious to see what they have to say. Does your house use this?